Fehlermeldung bei JTG
Verfasst: Di 03 Feb 2009, 19:00
moin,
nach install jtg ( Download hier im Forum)
Einstellung; Udrec, TS
kommt bei Sofortaufnahme Fehlermeldug
Udrec.exe-Common Language Runtime Debugging Service
Application has generated an exception that could not be handled.
Process id=0xce8(3304), Thread id=0xcec(3308)
Click ok to terminate the application.
Click Cancel to debug the application.
Nun Cancel geklickt.... dann folgt
udrec.exe-No debugger found
registered JIT debugger is not available.An attempt to launch a JIT debugger with the following command resulted in a error code of 0x2 (2). Please checkcomputer settings.
cordbg.exe!a 0xce8
Was ist hier zu tun ?
thx eisbaer
nach install jtg ( Download hier im Forum)
Einstellung; Udrec, TS
kommt bei Sofortaufnahme Fehlermeldug
Udrec.exe-Common Language Runtime Debugging Service
Application has generated an exception that could not be handled.
Process id=0xce8(3304), Thread id=0xcec(3308)
Click ok to terminate the application.
Click Cancel to debug the application.
Nun Cancel geklickt.... dann folgt
udrec.exe-No debugger found
registered JIT debugger is not available.An attempt to launch a JIT debugger with the following command resulted in a error code of 0x2 (2). Please checkcomputer settings.
cordbg.exe!a 0xce8
Was ist hier zu tun ?
thx eisbaer